 |
|
|
|
|
|
|
 |
|
|
ICD2 Clone (In-Circuit Debugger)
www.sixca.com
This is the small ICD2 clone. It has less than
credit card size on a single side PCB and
no external power require communicate with PC via
RS232
port.
With this ICD2 you can debug/program PICMicro devices and
dsPICs for more
infomation about PIC look at microchip website
This project no external power requires becuase it
use power supply from
target board and use
PWM to
generate high voltage for Vpp .
frequency about 38KHz.
I use PIC12C508A to generate PWM becuase it inexpensive and
no external component requires.PIC12F508A must programed with
file name eICD2_508A.hex
The main CPU for this ICD2 use PIC16F876A and the boot loader
for this CPU is ICD661.hex .If you want to use with PIC16F876 this file
not work .
BL010101.hex in c:\Program Files\Microchip\MPLAB
IDE\ICD2
should be use
for PIC16F876 but I not test.
This circuit work with PIC16F876A and PIC16F876 with
different boot
loader version.
This project test with MPLAB 6.5 it work fine.But not work with MPLAB
7.11 and another version I not test.
|
Schematic for ICD2 clone
L1 mounting
|
| |
|
To use this ICD2
If MCLR pin is weak-pulled up to Vdd at the target,
this resistor has to be removed when the ICD2 is connected since
our
ICD2 isn't able to pull this pin to ground.
You can download zipped file at the buttom of this page.
- circuit
- PCB
- BOM
All files are pdf format .
|
|
|
|
|
